Preon P2 LED Flashlight

·     LED: CREE XP-G R5

·     Max Output: 160 Out-the-front (OTF) lumens

·     Material: Hard-anodized Aircraft-grade Aluminum

·     Lens: Optical-grade glass lens with anti-reflective coating on both sides

·     Water resistance: IPX-8

·     Battery: Two AAA, included (see voltage range to select acceptable batteries for this light))

·     Operating Voltage Range: 0.9V-3.0V

·     Seven Output Modes:

Low: 2.2 OTF Lumens, 23 hours
Medium: 22 OTF Lumens, 6 hours
High: 160 OTF Lumens, 0.8 hours
Strobe
SOS
Beacon (Hi)
Beacon (Lo)

·     Dimensions:

Length: 5.05 inches
Diameter: 0.55 inches
Weight: 0.8 ounces

Included Accessories

·         Removable clip

Operation

Operating your Preon 2 is simple. Make sure its batteries are inserted with the positive side (+) toward the head. Ensure the tailcap is tightened. To turn the Preon on, tighten the bezel (the ‘head’ of the light) fully down and click the tailcap 'on'.

Selecting Regular Outputs

To select a different level of constant output, click the Preon off and then on again within 1 second (you can also "soft press" - see description at end). This will select the next level of constant output in the following sequence:

Low -> Medium -> High

If the Preon is turned off for 2 seconds or longer, it will revert back to Low.

Selecting Special Outputs

The Preon has 4 special output modes: Strobe, S.O.S., Beacon (Hi), and Beacon (Lo). To access these modes, quickly switch through two full 'cycles' of the regular outputs, starting with Low. These two full cycles must be completed within 3 seconds:

Low -> Medium -> High -> Low -> Medium -> High -> Special Outputs

You can continue to cycle through the special outputs in the following sequence:

Strobe -> S.O.S. -> Beacon (high) -> Beacon (low)

After Beacon (Lo) mode, the output reverts back to Regular Low. Both Beacon modes will first flash 5 times and then once every 10 seconds.

Soft Press